3D INTERNATIONAL LLC.

20724 CENTRE POINTE PARKWAY, UNIT 1

SANTA CLARITA, CA 91350

105 ACID MAG WIRE WHEEL CLEANER ( clear white liquid)

I . Hazardous Ingredients :

WT% CAS NO. TLV PEL

Hydrofluoric Acid 4 7664-39-3 3 6

Sulfuric Acid 9 7664-93-9 1 1

Phosphoric Acid 6 7664-38-2 1 1

Where available, Pel values listed are TWA final rule limits 1989 .

If no final rule exists, the transnational rule limit is listed.

II . Physical data

Melting point: N/D Specific Gravity : 1.507.

Boiling point : Above 200f SOLUBILITY IN

Water : Complete

Vapor pressure: ( MM HG ) >1 Evaporation Rate: N/D

Vapor density ( AIR=1 ) : >1 pH : < 1

Appearance : Clear water light liquid

III . Fire and Explosion Hazard Data :

Flash point : 200

Method used : T.C.C.

Autoignition Temperature : N/D

Flammable Limits : Upper N/D

Extinguishing Media : Dry Chemical, C02, and Water Spray

Fire and Explosion Hazard : Contact with reactive metals may produce flammable Hydrogen Gas.

Special fire fighting procedures : Wear goggles and self-contained breathing apparatus. Use water to cool

fire exposed containers and to flush spills away from fire. In the case of large fires, use cool surrounding

equipment and structures with water.

IV . Reactivity :

Stability : stable

Conditions to avoid : Stable under normal storage conditions.

Hazardous Polymerization : Will not occur

Incompatibility : Strong Oxidizing and reducing agents. Reactive metals.

Hazardous decomposition products : HCL Gas

V . Environmental and disposal information :

Small spill : Slowly neutralizes with diluted soda ash or lime to pH 6-9. If soda is used, provide adequate ventilation

dissipate the carbon dioxide gas. Mop up or soak up with Non-Combustible absorbent inorganic material. Transfer to

a dot-approved container

Large spill : Contain by diking with a Non-Combustible absorbent inorganic material. Prevent run off from entering

sewers, storm drains, surface water, and soil. Slowly neutralize with diluted soda ash or lime to pH between 6 and 9.

If soda ash is used, provide adequate ventilation to dissipate the carbon dioxide gas. Transfer contaminate absorbent

to a Dot-approved container.

Waste disposal information: Consult appropriate federal, State and local regulatory agencies to ascertain proper

disposal procedures.

Note: Comply with all applicable Government regulations on spill reporting and handling and disposal of waste.

Empty containers can have residues, gases, and mists, and are subject to proper disposal. VI . HEALTH HAZARD DATA :

Breathed: Vapors and mists of a components) are extremely corrosive to nose, throat, and mucous membrane.

The effect includes; irritation, coughing, chest pain, and difficulty in breathing bronchitis, pulmonary edema, and chemical pneumonitis.

Skin Contact : Vapors, mists and liquid of components) at full concentration will severely burn the skin.

Prolonged contact over a large area of the body may be fatal. Effects may be delayed.

Skin Absorption : Components are unlikely to be absorbed through skin in harmful concentrations.

Eye Contact : Vapors, mists, and liquids of a components) at full concentration are extremely corrosive to eyes.

Brief contact of the vapors will be severely irritating. Brief contact of the liquid will severely damage the eye.

Swallowed : Vapors, mists, and liquids of a components) are extremely corrosive to the mouth and throat

Swallowing the liquid burns the tissues causing severe abdominal pain, nausea, vomiting, and collapse.

Swallowing large quantities may be fatal.

Systemic and Other Effects :

Breathing mists and vapors may result in varying degrees of damage to attached tissues and thereby increase

susceptibility to respiratory illness.

Medical Conditions Aggravated :

No medical conditions are known to be aggravated by exposure to this product.

Suspected Cancer Agent :

Federal Osha: NO CA OSHA: NO NTP: NO IARC : NO

VII. First Aid :

Breathed : Remove victim to fresh air at once. If not breathing , give mouth to mouth resuscitation. If breathing

is difficult, give oxygen. Keep victim warm and at rest. Get immediate medical attention.

Skin : Wash skin immediately with lots of soap and water. If clothes and shoes are contaminated, remove and wash

before reuse. Get medical attention if infection or irritation develops.

Eyes : Wash eyes immediately with running water for at least 15 minutes. Use fingers to assure eyelids are separated

and that eye is being washed. Lift the lower and upper lid occasionally. Get immediate medical attention.

Swallowed : If victim is conscious give large amounts of water. Do not attempt to give liquids to unconscious person.

Note to Physician : Supportive case treatment based on judgment of physician to response to reactions of patient.

VIII. Handling Precautions :

Ventilation : Control airborne concentrations below exposure guidelines ( section I ) with mechanical ventilation's, IF

necessary. Local explosion-proof exhaust ventilation may be necessary for some operations.

Respiratory Protection : Atmospheric levels should be maintained below exposure guidelines. When respiratory

protection is required for certain operations, use an niosh-approved canister-type respirator. In confined or poorly

ventilated areas or for emergency and other conditions where the exposure guidelines may be greatly exceeded, use

an approved positive-pressure, self-contained breathing apparatus.

Eye Protection : Contact lenses should not be used. Contact lenses may increase the severity of the injury. Suggested

Protection is safety glasses, but where contact with liquid is likely chemical goggles or face shields are recommended.

Skin Protection : Impermeable gloves are recommended. When prolonged or frequently repeated contact could occur,

use protective clothing. Selection of specific items such as boots, apron, or full-body suite will depend on operation.

Wash thoroughly after handling chemicals.

Special Equipment : Suitable safety equipment includes safety showers, eyewashes , and proper fire extinguishing media.

IX . Storage and Handling :

Train all employees on all special handling procedures in this section before they work with this product. Exercise reasonable

care and caution. Personnel should avoid breathing vapors and/or mists getting products in the eyes or on the skin.

Do not consume food, drink, or tobacco in areas where they may become contaminated with this material. Keep containers cool

dry and away from sources of ignition. Do not store product in direct sunlight, high temperatures, or below freezing areas.

Keep product container tightly closed when not in use, Protect containers from physical damage. Use and store with adequate

ventilation. Do not cut, grind, weld or drill on or near this container. Ground all equipment, wash thoroughly after using.

Vent container frequently, and more often in warm weather, to relieve pressure.

X . Dot :

Proper shipping name : Acid, Liquid; N.O.S.

Hazard Class : Corrosive material

I.D NUMBER : UN1760

XI . OTHER PRECAUTIONS :

DISCLAIMER OF LIABILITY

The information contained herein is based on data considered accurate. However, the information is provided without any

warranty, expressed or implied, regarding it's correctness. The conditions or methods of handling, storage, use and disposal

of the product are beyond our control and may beyond our knowledge. For this and other reasons, we do not assume

responsibility and expressly disclaim liability for loss, damage or expense arising out of or in any way connected with

the handling, storage, use or disposal or this product.